THE AUTOMATED FLOWCHART DESIGN AND CODE WRITING SYSTEM

 

OPERATING SYSTEMS AND RESOURCE DEMANDS

LogicCoder uses a Graphical User Interface (GUI) to illustrate program Flowcharts. It does not require large amount of memory. However, it provides a relatively large number of functions. LogicCoder is a well programmed system that is implemented concisely.

LogicCoder is implemented to run under either the Ms Windows's operating system or DOS. The Ms Windows version of LogicCoder uses standard Ms Windows GUI. This implementation require more memory and other resources but provides a familiar Ms Windows interface for some users. The DOS version uses less familiar interface and less resources but provides the same functionality.

The DOS implementation of LogicCoder uses a simpler GUI, far less systems resource, and gives good performance on systems with lower specification to that required by the Ms Windows version.

HARDWARE AND SOFTWARE REQUIREMENT
If you are installing the DOS version of LogicCoder, then you should ensure that your system have the following capabilities:

Ms DOS 6 or higher
EGA, VGA, SVGA graphics capability
Also a ISO standard mouse
An Intel Pentium II or higher processor
At least 16 Mg of RAM
If you wish to run the system while Ms Windows run in the back ground, then you should increase the RAM to at least 32 Mg for reasonable performance.

If you are installing the Ms Windows version of the LogicCoder, then your system should meet the following minimum requirement:
Ms Windows 95 or higher, Ms Windows NT 3.01, 4.00
EGA, VGA, SVGA graphics capability
Also a ISO standard mouse
An Intel Pentium II or higher processor
At least 32 Mg of RAM